Basic Instructions:
- Shake the bottle.
- Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
- Print according to the filament/printer manufacturers recommendations
- Allow to cool and Remove. The print should pop right off
- Clean - Use a damp cloth to wipe off (except for Magigoo PP - see instructions below)
When doing larger printer using materials that have a tendency to warp (i.e. ABS, nylon, polycarbonate, polypropylene, etc.), a 20 mm brim is recommended. In cases of excess adhesion, it is recommended to wet the print bed with a small amount of water and slowly work it below the part. This should make part removal easier.
Important Note: The Magigoo applicator has an active spring valve, which activates when applicator is pressed against the build plate. Please do not squeeze the bottle when the applicator is not activated. Otherwise, the applicator may pop off. Bottle may be slightly squeezed, only when the nib is pressed against the bed and it may be necessary only if a greater rate of flow is required. Bottle must not be squeezed when cap is off at any other time, as it may result in glue popping out of the bottle.
Cleaning Instructions for Magigoo PP: Use a wet hard sponge to remove all glue residue. Once the glue layer is wet, it will form a white layer which can be easily scrubbed off with an abrasive sponge. Once the layer is completely loose from the glass it can be wiped away with a wet cloth and finally cleaned with a dry paper towel.